MacTCP

The most recent version of MacTCP is 2.06. You should not use any versions older than the most recent.  If you have an older version numbered 2.0 or greater you need to obtain 2.06

Configuring MacTCP.

Configuring MacTCP on your Macintosh dsl configuration and dialup configuration

                                                                                          dial up

1. In the obtain address box  click manually

2. enter the gateway address 63.167.32.1

3. click on the class box and change to C

4. Type in poi.net in the domain box

5. type in 63.167.32.3 in the first address box and select default

6. type in 63.167.32.5 in the second address box

7. select server in the obtain address box

8. click ok

Free PPP setup (if you have config ppp then skip down to it below)

FreePPP

1. Click the General tab Place an 'X' in the check line every 20 seconds and show alerts box
2. Click the modem setup button.
   
   
   
   
   
3. Make sure the settings above match yours on your computer then click ok
4. Click on acounts
5. 
   
   
   
   Highlight poi then click edit button
   
   
   
   
   
6. Make sure your picture looks like the above then click ok
   
   
   
   
   
   
7. Set the port speed: to 57600 and set the flow control:' to CTS only.
8. Click on the Options tab.
   
   
   
   
9. Make your screen look like the picture above then click the ok button
   
   
   

Config PPP section

1. Make sure your screen looks like the one above with the right items checked off. REMEMBER THIS SECTION PRETAINS TO CONFIGPPP only

1. Make sure your setting are exactly as the picture above
2. Click the Authentication button
   
   
   
   
   
   
3. Make sure your setting are exactly as the picture above
4. Click Ok

Back to poinet